EASYSTEAM ES100
Brochure download

ELECTRODE STEAM HUMIDIFIERS

Easysteam ES is the most evolved and flexible solution for steam humidification of any environment. The integrated electronic control permits to configure and optimize the humidifier on the basis of customer's specific requirements and to guarantee its long-lasting thanks to diagnostic routines. Stainless steel removable front cover, spring clamps cylinders and quick connection power connector permit a rapid and simple maintenance. The full range of models and accessories satisfy all installation requirements.

Pego Electrode steam humidifiers ES100

 

Pego Electrode steam humidifiers ES100

 

 

 

Applications
Steam/humidity generator for industrial plants, offices, civil facilities, call centres, hotels, museums and bookshops, technological or medical facilities, tobacco industry, food industry, seasoning, wood industry, paper mills, printing industries and steam rooms.

Main characteristics
Electrodes steam humidifiers.
Three-phase power supply versions with steam producing of 96 kg/h.
Master/slave humidifiers management (up to 3 ES100 units) to reach steam productions up to 288 kg/h.
Structure entirely of stainless steel and abs plastic.
Easily interchangeable cylinders with steel electrodes, limestone filter on the bottom, maximum level sensor and connector connections.
Solenoid valves for water charging.
Tough and reliable drain pumps.
"Smart production for low conductivity" function; the humidifier automatically regulates the percentage of steam production based on the conductivity of the water.
Available cylinders for low conductivity water (minimum conductivity limit 125 μs/cm).
Double integrated electronic control.
Large accessories range.

Electronic control
Featuring numerous parameters and an user-friendly display, the EASYSTEAM controller allows precise setting of humidifiers performance. Thanks to the high number of available variables it is possible to personalize humidifier functioning on the basis of customer requirements.
Eight operating modes can be set among which ON/OFF from external contact, proportional with built-in humidistat and 4-20mA or 0-10V probe, proportional with external 0-10V signal. Built-in thermostat ON/OFF. BMS control via Modbus.
Duct probe management.
Optimised use for steam baths thanks to the built-in temperature control, essence management, inlet and exhaust fan control.
Settable with maximum capacity.
Proportional regulation of steam dispensing from 20% to 100%.
Steam dispensing reduction from digital input.
Programmable automatic drainage when not used.
Management of up to 3 ES100 humidifiers in battery with master/slave configuration.
Humidifier operating hour meter.
Maximum level sensor management.
Control console with large display and status icons for reading and programming work data remotely up to 100 m away with a simple phone cable.
Diagnostics for problems identifying or maintenance need.

 

TECHNICAL CHARACTERISTICS
ES100
Dimension (mm)
525x730x670
Empty weight 80 Kg
Working weight 160 Kg
Steam production 96 Kg/h
Electrical power supply
400V 3/N 50 Hz
Power 71 kW
Absorption
102 A
Electronic control CONSOLLE NANO + MASTER HUM2 (x2)
Power supply control

230V 50/60 Hz
Steam connector 4 x 40 mm
Water charging connection

3/4"G male
Water discharge connection 40 mm
Number of cylinders 4
Water pressure

1-10 Bar
Limits of water's hardness
160-450 mg/l CaCO3
Conductivity of water 250-1300 µS/cm
Fan unit

n° 4, OPTIONAL

Remote mounting

DIMENSION

Pego Humidifier ES100

 

DOWNLOAD INSTRUCTION
Instruction manual